| |
| Weber touch slicer basic maintenance |
| |
|
| Participants: |
Maintenance personnel familiar with the Weber
Touch slicer and a minimum of three months
experience with Weber slicers |
| |
|
| Course Objectives: |
Upon completion of this course, participants
will demonstrate the following: |
| |
|
| |
| » |
The ability to complete hands on exercises to demonstrate proficiency of using and navigating through the Weber Touch Screen system. |
| » |
The ability to use the Maintenance menus and Maintenance functions of the Touch application. |
| » |
Demonstrate electrical drawing familiarity by using the electrical drawings to locate control circuit and load circuit connection points and device wiring configurations |
| » |
The ability to apply troubleshooting principals to diagnose actual electro-mechanical failures |
|
| |
|
| Contents: |
| Basic Trouble Shooting Methods |
| » |
Problem categorization |
| » |
Sequence of events slicer reference |
| » |
Sequence of events normal operation |
| » |
Error Protocol |
| |
|
| Touch Screen and Slicer Basics |
| » |
Slicer Parts and Terminology |
| » |
Weber Touch Screen Operation |
| » |
Slicer Program Parameters function and Optimization |
| » |
Maintenance Administrative Functions |
| |
|
| Electrical System Functions |
| » |
Overview of Control System |
| » |
Elau Drive Systems |
| » |
Electrical Drawings |
| |
|
| Weber Checkweigher System |
| » |
Function |
| » |
Components |
| |
|
|
| Place of Training: |
Weber Inc., Kansas City |
| |
|
| |
|
|
|
| Touch slicer advanced maintenance |
| |
|
| Participants: |
Maintenance personnel that can demonstrate troubleshooting proficiency and knowledge of
Weber Touch slicers by successfully completin
an entry exam or having completed the Basic Maintenance training course |
| |
|
| Course Objectives: |
Upon completion of this course, participant
will demonstrate the following: |
| |
|
| |
| » |
The ability to properly backup vital slicer PC files and the ability to use those files to program a new slicer PC |
| |
The ability to update Touch software versions |
| » |
The ability to update PacDrive (C400/Max4) slicer software versions |
| » |
Proper installation and configuration of PacDrive (C400/Max4) |
| » |
The ability to use the Elau firmware tool to correct firmware compatibility issues |
| » |
The ability to diagnose PC to PacDrive (C400/Max4) communication issues |
| » |
The ability to setup slicer PC network configurations |
| |
|
|
| Contents: |
| » |
Slicer PC Configuration |
| » |
PacDrive (C400/Max4) Firmware and Software Configuration |
| » |
Touch Application versions |
| » |
Elau PacDrive (C400/Max4) firmware compatability |
| » |
Slicer Communication systems |
| |
|
|
| Place of Training: |
Weber Inc., Kansas City |
| |
|
|
